FILLERS

EPOMAST

EPOMAST

CODE 6662
GENERAL PURPOSE EPOXY FILLER
High-strength two-pack epoxy filler with great mechanical resistence. Excellent adherence to any type of surface and to epoxy primers. Highly resistant to water. Epomast can be used to make joints and can be used to repair heavily damaged surfaces. Thicknesses of up to 10 mm can be reconstructed using a spatula and Epomast can be applied directly to wood, GRP, previously disc-ground steel and aluminium.
6610 for cleaning only
1:1
7h (20°C)
1L=1 m2

Packaging

0,5 Kg
754
2 Kg
754
EPOMAST EVO

EPOMAST EVO

CODE 6660
ULTRA-LIGHT EPOXY FILLER
An epoxy filler of the latest generation, formulated to provide homogeneous consistency and avoidance of air bubbles during application. Epomast Evo is easy to apply and to sand and - after curing - provides excellent mechanical properties such as flexibility and good resistance to compression. Suitable for application on boats made of steel, aluminium, GRP and wood. Epomast Evo can be used also for levelling deeper surface defects, when applied with several passes. Suitable for filling both areas above and below the waterline. Can be used also - owing to its creamy consistency and fine grain - as a knifing filler for the application of finishing paints.
6610 for cleaning only
1:1
7days (20°C)
1L=1 m2

Packaging

1,5 L
118
10 L
118
EPOMAST RAPIDO

EPOMAST RAPIDO

CODE 6604
FAST DRYING EPOXY KNIFING FILLER
Two-pack, fast drying, high resistance epoxy filler designed for final profiling and small repairs. Can be applied up to a thickness of 1 cm with one single-pass. Epomast Rapido can be applied to any kind of substrate after the application of a suitable primer. Can be applied onto Epomast Pro or to suitable epoxy undercoats both on below and above waterline areas. For best results, prior to the application of a topcoat, a suitable barriercoat or undercoat are recommended. Easy to sand in a short time, both dry and wet conditions.
6610 for cleaning only
1:1
7days (20°C)
1L=1 m2

Packaging

0,5 L
153
STUCCO VELOX

STUCCO VELOX

CODE 6332
ONE-PACK CONVENTIONAL FINISHING FILLER
Stucco Velox is generally used for final smoothing as part of one-pack systems used on topsides and superstructure with a maximum thickness of one millimetre per coat. It should not be used in systems subject to continuous or intermittent immersion in water. Application in thicknesses of more than one millimetre can cause cracking in one-pack systems used for topsides and superstructures. Stucco Velox can be painted over with alkyd undercoats and finishes such as Eurogel, Italia and Unigloss.
6470 for cleaning only
24-36h (20°C)

Packaging

0,75 L
153
SUB COAT XT

SUB COAT XT

CODE 6612
TWO-PACK EPOXY FILLER FOR UNDERWATER APPLICATION
A pure epoxy compound, 100% solids by volume, which can remove water from the surface to be treated,providing excellent adhesion even on wet surfaces. Particularly useful for temporary repairs of leaks and cracks in the boat when it is in the water or moving. Subcoat S adheres easily to GRP, gel coats, old epoxies, epoxy tar as well as steel and concrete. It is suitable for temporary repairs on seachests, boot topping and submerged parts of cement quays. It is resistant to temperatures up to 100°C.
6610 for cleaning only
1:1
Max 10days (20°C)

Packaging

2 Kg
600